S-200C does not contain any heavy metals, cyanide, or chlorinated hydrocarbons. The data shown yellow can be changes to recallate the selected variables. After 15 minutes set to hot sputter for 1200. / Units for Kinematic Viscosity: ft 2 / s mm 2 / s m 2 / s The following table defines the average Kinematic Viscosity for selected liquid fluids. ANALYSIS FOR HEAVY METALS, CYANIDE, AND CHLORINATED HYDROCARBONS Temperature Ramp Results in Air with varying bridge voltages. Staphylococcus Coagulase positive: Negative Test results regarding the determination of the presence of the following: Minimum and maximum pH, temperature, and salinity levels below or above which the effectiveness of the additive is reduced to half its optimum capacity:ĥ. Optimum pH, temperature, and salinity ranges for use of the additive:ģ. However, with the addition of S-200C, the microbiological data shows a continued viability of microbial incubations over time.Ģ. S-200C is a nutrient bioremediation accelerator and does not contain bacterial cultures or amendments. Listing of all microorganisms by species and percentages in the composition: Percentage (%) Decrease in Weight of Oil on Day 28ġ. 6 diesel fuel, jet fuels, kerosene, lubricating oils, hydraulic oils, and crude oils.īioremediation Agent Effectiveness Test (40 CFR 300.900), Federal Register September 15, 1994: These hydrocarbons include but are not limited to gasoline, No. It is a non-intrusive, cost effective remedy for the cleanup of these hydrocarbons. S-200C is a bioremediation accelerator used for the remediation of hydrocarbon spills or leaks. To remediate a sheen on water, the same application ratio for a surface application is used. The amount sprayed is dependent on the amount of hydrocarbon on the surface you are spraying. On a surface application, the amount to use is approximately 0.1 to 1 pound of S-200C for every square yard of surface area. This allows air to circulate and thereby maintains an aerobic condition. In other words, use 1 pound of S-200C for every 10 pounds of hydrocarbon you are remediating.įor applications on soil contaminated below 1 foot, the soil is turned and the material is applied. The recommended application rate is approximately 10% by volume of the S-200C as compared to the hydrocarbon being remediated. S-200C is a light amber liquid, and as such can be sprayed with traditional liquid spraying equipment, such as pressurized sprayers or backpack sprayers. Recommended shelf life of S-200C is 10 years if kept in the unopened, original container. Optimum storage temperature range: 55✯ - 85✯Ĥ.d. In case of contact with skin or eyes, wash with plenty of water.Ĥ.c. Skin and eye contact protective clothing treatment in case of contact: Ventilation of the work place is not necessary.ģ. SPECIAL HANDLING AND WORKER PRECAUTIONS FOR STORAGE AND FIELD APPLICATION NAME, ADDRESS, AND TELEPHONE NUMBER OF PRIMARY DISTRIBUTORS (*RBL Environmental, LLC is the manufacturer and marketer for International Environmental Products) NAME, ADDRESS, AND TELEPHONE NUMBER OF MANUFACTURER/CONTACT Type of Product: Bioremediation Agent (Nutrient Additive) USEPA, OEM REGULATIONS IMPLEMENTATION DIVISION
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |